mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Fuel System Pressure Relief|Page 4670 > < Battery - Application Guide/Cold Cranking Amp Specs.|Page 4667
Page 1
background image

Battery: Service Precautions
Fuel System Pressure Relief

1. Disconnect fuel pump harness connector at fuel tank rear side. Cover fuel pipe line with rag after relieving pressure as certain pressure may

still remain.

2. Start engine and let idle until all fuel has been burned, then turn ignition switch to Off position. Failure to relieve fuel system pressure prior to

disconnecting fuel system components may cause fire or personal injury.

3. Disconnect negative battery ground cable.
4. Connect fuel pump harness connector.
5. After repairs have been completed, connect positive battery terminal to fuel pump drive terminal and the negative terminal to the chassis. Ensure

fuel pump operates at this time.

Fuel System Pressure Relief|Page 4670 > < Battery - Application Guide/Cold Cranking Amp Specs.|Page 4667