Galant L4-2.0L SOHC (1989)
Instrument Cluster / Carrier: All Technical Service Bulletins
Instruments - Combination Meter Squeaking Noise
SUBJECT:
EARLY 1989 GALANT COMBINATION
METER SQUEAK
NO.
TSB-90-52-001
DATE
January, 1990
MODEL Galant
PURPOSE
This bulletin describes the procedure for correcting a squeaking noise coming from the combination meter area of some 1989 Galant vehicles when
traveling over rough roads. This squeak comes from between the combination meter bezel and the combination meter housing. This condition has been
corrected in production as of March 1, 1989.
PARTS REQUIRED
Electrical Tape
Figure 1
REPAIR PROCEDURE
1.
Unscrew the Trip Meter Reset Knob.
2.
Remove the 2 installation screws, and then remove the meter bezel by using a plastic trim tool in the location shown in figure 1.
CAUTION:
EXCESSIVE FORCE WILL DAMAGE THE BEZEL!
Figure 2
3.
Loosen the 4 combination meter mounting screws 2 turns. Carefully push the combination meter upward and while holding the combination meter
up, tighten the 4 mounting screws (Figure 2).
