Galant L4-2.0L SOHC (1989)
Alignment: Service and Repair
Rear Toe-In
FWD Models
Rear toe-in is preset to specifications and cannot adjusted. If rear toe-in is out of specification, bent or damaged components must be replaced.
AWD Models
1.
Measure toe-in using a suitable toe-in gauge.
2.
If toe-in is not within specifications, adjust by equally moving the mounting bolts located on the crossmember side of the trailing arm. Moving the
adjusting bolts one division on the scale will adjust the toe-in about .08 inch.
2.
If toe-in is not within specifications, adjust by equally moving the mounting bolts located on the crossmember side of the trailing arm. Moving the
adjusting bolts one division on the scale will adjust the toe-in about .08 inch.
