Galant L4-2.0L SOHC (1989)
Remove the taper roller bearing using the special tool as illustrated.
CAUTION:
1. Do not reuse the bearing removed from the differential case.
2. Replace the inner and outer races of the taper roller bearing as a set.
4. REMOVAL OF LOCK PIN
Drive out the lock pin from the hole A using a punch.
SERVICE POINTS OF REASSEMBLY
9. INSTALLATION OF SPACER / 8. SIDE GEAR / 7. WASHER / 6. PINION / 5. PINION SHAFT
1. Install the spacer on the back of the side gear and then install the gear in the differential case.
CAUTION: When installing a new side gear, use a spacer of medium thickness [0.93 - 1.00 mm (0.37 - 0.39 in.)].
2. Set the washer on the back of each pinion and insert the two pinions to specified position while engaging them with the side gears and turning
them.
3. Insert the pinion shaft.
