Galant L4-2.0L SOHC (1989)
4. Measure the backlash between the side gears and pinions.
Standard value: 0.025 - 0.150 mm (0.001 - 0.006 in.)
5. If the backlash is out of specification, disassemble again and using correct spacer, reassemble and adjust.
CAUTION: Adjust for same backlash of both side gears.
4. INSTALLATION OF LOCK PIN
Align the pinion shaft lock pin hole with the case lock pin hole and insert the lock pin.
CAUTION:
1. Do not reuse the lock pin.
2. The lock pin head must be sunk from the flange surface of the differential case.
3. INSTALLATION OF TAPER ROLLER BEARING
Install the taper roller bearings on both sides of the differential case.
CAUTION: When press-fitting the bearings, push the inner race only.
1. INSTALLATION OF BOLTS
