Galant L4-2.4L (4G69) (2004)
/Page-1365016.png)
2. Measure the resistance by operating the remote controlled radio switch (RH) in each position.
Q: Are the resistance at the right remote controlled radio switch normal?
YES: Go to Step 2.
NO: Replace the remote controlled radio switch (RH).
STEP 2. Check the remote controlled radio switch (RH) connector C-301 and clock spring connector C-303 for loose, corroded or damaged
terminals, or terminals pushed back in the connector.
Q: Is remote controlled radio switch (RH) connector C-301 and clock spring connector C-303 in good condition?
YES: Go to Step 3.
NO: Repair or replace it. Refer to Harness Connector Inspection. The remote controlled radio switch (RH) should work normally.
