Galant L4-2.4L (4G69) (2004)
STEP 12. Check the wiring harness between multi-center display unit (middle grade type) connector C-05 (terminal 2) and ignition switch
(IG1).
NOTE: Also check joint connector (2) C-03, junction block connector C-211 and C-215 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If joint connector (2) C-03 or junction block connector C-211 or C-215 is damaged, repair or replace the wiring harness. Refer to
Harness Connector Inspection.
Q: Is the wiring harness between multi-center display unit (middle grade type) connector C-05 (terminal 2) and ignition switch (IG1) in good condition?
YES: The procedure is complete.
NO: Repair the wiring harness. The multi-center display unit (middle grade type) should work normally.
Inspection Procedure 3
The multi-center display does not Show any Information. (low Grade type)