Galant L4-2.4L (4G69) (2004)
STEP 14. Check the wiring harness between ETACS-ECU connector C-219 (terminals 12 and 13) and rear door lock actuator (LH) connector
E-18 (terminals 4 and 6).
NOTE: Also check intermediate connector D-19 and junction block connector C-204 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If intermediate connector D-19 or junction block connector C-204 is damaged, repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q : Is the wiring harness between ETACS-ECU connector C-219 (terminals 12 and 13) and rear door lock actuator (LH) connector E-18 (terminals 4
and 6) in good condition?
YES : Replace the ETACS-ECU. Verify that all the doors can be locked and unlocked normally.
NO : The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that all the doors can be locked and unlocked.
STEP 15. Check rear door lock actuator (RH) connector E-08 for loose, corroded or damaged terminals, or terminals pushed back in the
connector.
Q : Is rear door lock actuator (RH) connector E-08 in good condition?
YES : Go to Step 16.
NO : Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that all the doors can be locked and unlocked
normally.