mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2575 > < Initial Inspection and Diagnostic Overview|Page 2573
Page 140
background image

STEP 16. Check the rear power window regulator motor (LH).

1. Remove the rear power window regulator assembly (LH). Refer to Door, Door Glass and Regulator.
2. Connect a battery to the motor terminal, and check that the motor runs freely.

Q : Is the rear power window regulator motor (LH) normal?

YES : Go to Step 17.

NO : Replace the rear power regulator assembly (LH). When the rear power window sub switch (LH) is operated, the rear power window (LH)
should raise and lower normally.

STEP 17. Check the battery power supply circuit to the rear power window sub switch (LH). Measure the voltage at rear power window sub
switch (LH) connector E-17.

1. Disconnect rear power window sub switch (LH) connector E-17 and measure the voltage available at the wiring harness side of the connector.

Initial Inspection and Diagnostic Overview|Page 2575 > < Initial Inspection and Diagnostic Overview|Page 2573