Galant L4-2.4L (4G69) (2004)
Q : Is sunroof motor assembly connector D-04 in good condition?
YES : Go to Step 2.
NO : Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Check that the sunroof works normally.
STEP 2. Check the fusible link (5) line of power supply circuit to the sunroof motor assembly. Measure the voltage at sunroof motor assembly
connector D-04.
1. Disconnect sunroof motor assembly connector D-04 and measure the voltage available at the wiring harness side of the connector.
2. Measure the voltage between terminal 1 and ground.
-
The voltage should measure approximately 12 volts (battery positive voltage).
Q : Is the measured voltage approximately 12 volts (battery positive voltage)?
YES : Go to Step 4.
NO : Go to Step 3.