Galant L4-2.4L (4G69) (2004)
YES : Replace the ETACS-ECU. Verify that the turn-signal lights illuminate normally.
NO : Refer to Inspection Procedure M-5 "ETACS-ECU does not receive any signal from the turn-signal light switch."
Inspection Procedure I-2
Flasher Timer: Hazard warning lights do not flash when the hazard warning light switch is turned on.
CIRCUIT OPERATION
If the ETACS-ECU receives "ON" signal from the hazard warning light switch, the ETACS-ECU turns on the flasher timer (incorporated in the
ETACS-ECU), thus causing the turn-signal lights to flash.
TECHNICAL DESCRIPTION (COMMENT)
If the hazard warning lights do not flash, the power supply line to the ETACS-ECU (dedicated to the turn-signal lights) or the ETACS-ECU may be
defective.
TROUBLESHOOTING HINTS
-
Trouble in input signal system
-
The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
-
The ETACS-ECU may be defective
DIAGNOSIS
Required Special Tools:
-
MB991223: Harness Set
-
MB991958: Scan Tool (MUT-III Sub Assembly)
-
MB991824: Vehicle Communication Interface (V.C.I.)
-
MB991827: MUT-III USB Cable
-
MB991910: MUT-III Main Harness A