Galant L4-2.4L (4G69) (2004)
STEP 2. Check front combination light (LH) connector A-18 for loose, corroded or damaged terminals, or terminals pushed back in the
connector.
Q : Is front combination light (LH) connector A-18 in good condition?
YES : Go to Step 3.
NO : Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the turn-signal lights illuminate normally.
STEP 3. Check the front turn-signal light bulb (LH).
1. Remove the front turn-signal (LH) light bulb.
2. Verify that the front turn-signal light bulb (LH) is not damaged or burned out.
Q : Is the front turn-signal (LH) light bulb in good condition?
YES : Go to Step 4.
NO : Replace the front turn-signal (LH) light bulb. Verify that the turn-signal lights illuminate normally.
STEP 4. Check the ground circuit to the ETACS-ECU. Measure the resistance at front combination light (LH) connector A-18.
1. Disconnect front combination light (LH) connector A-18 and measure the resistance available at the wiring harness side of the connector.
2. Measure the resistance value between terminal 2 and ground.
-
The resistance should be 2 ohms or less.
Q : Is the measured resistance 2 ohms or less?