Galant L4-2.4L (4G69) (2004)
STEP 23. Check ABS-ECU connector A-02 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
CAUTION: The strand end of the twisted wire should be within 10 cm (4 inches) from the connector. For details refer to Service Precautions/Vehicle
Damage Warnings.
Q: Is ABS-ECU connector A-02 in good condition?
YES: Go to Step 24.
NO: Repair the damaged parts.
STEP 24. Check the CAN_H line (communication line only) between intermediate connector C-29 and ABS-ECU connector for a short to the
power supply. Measure the voltage at intermediate connector C-29.
CAUTION: A digital multimeter should be used. For details refer to Service Precautions/Vehicle Damage Warnings.
CAUTION: The test wiring harness should be used. For details refer to Service Precautions/Vehicle Damage Warnings.
1. Disconnect intermediate connector C-29 and ABS-ECU connector A-02, and measure the voltage at the male side of intermediate connector C-29
(at front wiring harness side).
2. Turn the ignition switch to the "ON" position.