Galant L4-2.4L (4G69) (2004)
4. Measure the resistance between intermediate connector terminals 22 and 23.
OK: 1 kOhm or more
Q: Does the resistance measure 1 kOhm or more?
YES: If the resistance measures 1 kOhm or more, go to Step 20.
NO: If the resistance measures less than 1 kOhm, repair the wiring harness between intermediate connector C-29 and SRS-ECU connector.
STEP 20. Check SRS-ECU connector C-121 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
CAUTION: The strand end of the twisted wire should be within 10 cm (4 inches) from the connector. For details refer to Service Precautions/Vehicle
Damage Warnings.
Q: Is SRS-ECU connector C-121 in good condition?
YES: Go to Step 21.
NO: Repair the damaged parts.
STEP 21. Check the SRS-ECU for short circuit. Measure the resistance at SRS-ECU connector C-121.
CAUTION: A digital multimeter should be used. For details refer to Service Precautions/Vehicle Damage Warnings.