Galant L4-2.4L (4G69) (2004)
4. Measure the resistance between joint connector (3) terminals 4 and 15.
OK: 1 kOhm or more
CAUTION: Strictly observe the specified wiring harness repair procedure. For details refer to Service Precautions/Vehicle Damage Warnings.
Q: Does the resistance measure 1 kOhm or more?
YES: If the resistance measures 1 kOhm or more, go to Step 7.
NO: If the resistance measures less than 1 kOhm, repair the wiring harness between joint connector (3) and the combination meter connector.
STEP 7. Check the combination meter for short circuit. Measure the resistance at combination meter connector C-101.
CAUTION: A digital multimeter should be used. For details refer to Service Precautions/Vehicle Damage Warnings.
1. Disconnect combination meter C-101, and measure the resistance at the component side of combination meter connector C-101.