Galant L4-2.4L (4G69) (2004)
/Page-650779.png)
4. Measure the resistance between intermediate connector terminals 11 and 12.
OK: 1 kOhm or more
Q: Does the resistance measure 1 kOhm or more?
YES: If the resistance measures 1 kOhm or more, go to Step 32.
NO: If the resistance measures less than 1 kOhm, repair the wiring harness between intermediate connector C-29 and ABS-ECU connector.
STEP 32. Check powertrain control module connector B-19 for loose, corroded or damaged terminals, or terminals pushed back in the
connector.
CAUTION: The strand end of the twisted wire should be within 10 cm (4 inches) from the connector. For details refer to Service Precautions/Vehicle
Damage Warnings.
Q: Is powertrain control module connector B-19 in good condition?
