Galant L4-2.4L (4G69) (2004)
2. Measure the resistance between ABS-ECU connector terminals 7 and 23.
OK: 2 ohms or less
3. Measure the resistance between ABS-ECU connector terminals 24 and 25.
OK: 2 ohms or less
Q: Do all the resistances measure 2 ohms or less?
YES: If all the resistances measure 2 ohms or less, go to Step 8.
NO: If either of the resistances measures more than 2 ohms or all the resistances measure more than 2 ohms, replace the ABS-ECU.
Step 15. Check the CAN bus lines (communication line only) between joint connector (3) and the data link connector. Measure the resistance at
joint connector (3) C-02 and data link connector C-125.
CAUTION: A digital multimeter should be used. For details Service Precautions/Vehicle Damage Warnings.
CAUTION: The test wiring harness should be used. For details Service Precautions/Vehicle Damage Warnings.