Galant L4-2.4L (4G69) (2004)
TECHNICAL DESCRIPTION (COMMENT)
The immobilizer indicator light or a malfunction of the combination meter or immobilizer-ECU.
TROUBLESHOOTING HINTS
-
Malfunction of combination meter
-
Malfunction of immobilizer-ECU
-
The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
DIAGNOSIS
Required Special Tool:
-
MB991223: Harness Set
STEP 1. Check immobilizer-ECU connector C-124 for loose, corroded or damaged terminals, or terminals pushed back in the connector
Q: Is immobilizer-ECU connector C-124 in good condition?
YES: Go to Step 2.
NO: Repair or replace the component(s). Refer to Harness Connector Inspection. Confirm that scan tool MB991958 communicates normally.
STEP 2. Check the immobilizer indicator light circuit of immobilizer-ECU connector C-124.
1. Disconnect the immobilizer-ECU connector C-124 and measure at the harness side.
2. Turn the ignition switch to the "ON" position.
3. Connect terminal 5 to the ground.