Galant V6-2972cc 3.0L SOHC (1988)
Clutch Disc: Service and Repair
1.
Remove transmission as described under ``Transmission, Replace.''
2.
Insert tool MD998126 or equivalent into center hole to prevent dropping of clutch disc, then diagonally loosen bolts that hold clutch cover
assembly to remove clutch cover assembly. Do not clean clutch disc or release bearing with cleaning solvent.
3.
Remove snap ring, clevis pin and release cylinder assembly if equipped.
4.
Remove return clip, then the release bearing.
5.
Remove spring pins from clutch release fork and shaft using a suitable punch.
6.
Install release shaft and packings, then the return spring and release fork.
7.
Align lock pin holes of shift arm and control shaft and, using tool MD998245 or equivalent, drive in two new spring pins.
8.
When installing spring pins ensure that spring pin slot direction is at right angles to center line of control shaft.
9.
Remove grease from clutch facing by wiping with clean cloth.
10.
Apply small amount of grease to clutch disc spline and input shaft spline.
11.
Using tool MD998126 or equivalent, install clutch disc and clutch cover assembly to flywheel. When installing clutch disc, make certain that
surface with manufacturer's stamped mark is on pressure plate side.
