Galant V6-3.0L SOHC (2003)
Wheel Speed Sensor: Testing and Inspection
WHEEL SPEED SENSOR OUTPUT VOLTAGE MEASUREMENT
Required Special Tool:
^
MB991219: Inspection Harness
1. Lift up the vehicle and release the parking brake.
2. Disconnect the ABS-ECU connector, and then use special tool MB991219 to measure the output voltage at the harness side connector.
3. Manually turn the wheel to be measured 1/2 to 1 turn/second. Measure the output voltage with a voltmeter or oscilloscope.
Output voltage:
^
When measured with voltmeter: 42 mV or more
^
When measured with an oscilloscope (maximum voltage): 120 mV or more
Probable causes of low output voltage
^
Wheel speed sensor pole piece-to-ABS rotor clearance too large
^
Faulty wheel speed sensor
NOTE: Check the connection of the sensor harness and connector before using the oscilloscope.
4. To observe the waveform with an oscilloscope:
^
Front Wheels: Shift into low gear and drive the wheels.
^
Rear Wheels: Turn the wheels manually at a constant speed
NOTE: The output waveform is low when the wheel speed is low. Similarly, it will be higher as the wheel speed increases. Waveform may
also be observed by driving the vehicle.
