Galant V6-3.0L SOHC (2003)
6. Cut with a nipper, etc. the instrumental panel wire ring harness shown in the Figure of the instructions, while the C-62 clock spring connector is
disconnected.
NOTE: The disconnection location should be sufficiently away from the C-62 harness side connector with consideration to the expansion harness
connection location upon disconnections.
7. Individually connect a harness on the two harnesses disconnected, cover the connection areas with insulation tape and then pull out the expansion
harness outside the vehicle.
8. Connect the C-62 harness side connector connected with an expansion harness to the C-62 clock spring connector.
WARNING: If the glass is scratched, air bag deployment could cause it to crack and fly out of the vehicle, so always put a cover over the
vehicle.
9. To suppress the operation sound as much as possible completely close all door windows, close the doors and put the cover on the vehicle.
WARNING: Before deploying the air bag in this manner, first check to be sure that there is no one in or near the vehicle. Wear safety glasses.
The inflator will be quite hot immediately following the deployment, so wait at least 30 minutes to allow it to cool before
attempting to handle it. Although not poisonous, do not inhale gas from the air bag deployment. See Deployed Air Bag Module
Disposal for post-deployment handling instructions.
If the air bag module fails to deploy, do not go near the module. Contact the MMSA Tech Line.
10. At a location as far away from the vehicle as possible, disconnect the two connected wires from each other, and connect them to the two terminals
of the battery (which has been removed from the vehicle) to deploy the air bag.
11. After deployment, dispose of the air bag module according to the Deployed Air Bag Module Disposal Procedures.
DEPLOYMENT INSIDE THE VEHICLE (when disposing of a vehicle) <Air bag module (front passenger's side)>
1. Move the vehicle to an isolated spot.
DANGER:Wait at least 60 seconds after disconnecting the battery cables before doing any further work.
WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
2. Disconnect the negative (-) and positive (+) battery cables from the battery terminals, and then remove the battery from the vehicle.
3. Remove the glove box.
