Galant AWD L4-1997cc 2.0L DOHC Turbo (1991)
Technical Service Bulletin # EMR92005R
Date: 920101
Recall - Oxygen Sensor Replacement
NO.:
EMR-92-005 Revision
DATE:
January, 1992
MODEL:
1991-1992 Galant VR-4
SUBJECT:
1991 - 1992 FEDERAL GALANT VR4
EMISSION RECALL
This bulletin supercedes EMR-92-005, which should be discarded.
PURPOSE
This bulletin provides a detailed procedure for inspection and repair of the emission control system on certain turbocharged 1991 and 1992 2.0L Federal
Emission Certified Galant VR-4 models. A letter has been sent to all owners of the affected vehicles informing them to return their vehicles to their
Mitsubishi Motors dealer to have the engine serviced. A copy of this letter is shown on Page 6 of this bulletin.
Please note that the customer is not to be charged for the repairs covered by this bulletin. To achieve the desired results, the procedure MUST be
followed EXACTLY as described in this bulletin.
IMPORTANT NOTICE
All dealerships MUST perform all steps described in this bulletin. Incomplete repairs will lead to emissions non-compliance and obvious customer
dissatisfaction. The Environmental Protection Agency (EPA) will survey the results of this campaign several months after starting. If incomplete repairs
or non-compliance is found, another recall could be ordered or other action undertaken by EPA.
Furthermore, the EPA may consider failure to properly perform emission recall procedures as tampering, which may subject the servicing dealer to a fine
of up to $25,000 per vehicle. Confirm that you are using the proper Technical Service Bulletin repair procedures and service kits for the vehicle model
year and engine size that you are working on. Service procedures are different even though some vehicles may look alike.
AFFECTED VEHICLES
This procedure applies to 1991 and 1992 2.0L Federal Emission Certified Galant VR-4 models equipped with manual transmissions without limitation as
to mileage. It does not apply to any other models.
REQUIRED OPERATIONS
1.
Replace the Oxygen Sensor.
2.
Clear any diagnostic codes stored in the MPI system's ECU using the Multi-Use Tester.
PARTS INFORMATION
Oxygen sensor:
MD188208
Required on each claim. No other parts are allowed to be claimed.
WARRANTY INFORMATION
Submit as Recall Claim type "C", Menu option "E-5" on your Diamond Network System.
Do NOT submit as "W" claims!
Required Operation
Labor Operation Code:
C9206XXX
Time allowance:
0.2 hr.
Note:
The "O" in the above labor code is the number ZERO.