Galant ES L4-2350cc 2.4L SOHC MFI (1997)
(8) Adjust the timing belt tension.
>C< Timing Belt Tension Adjustment.
(1) After turning the crankshaft 1/4 of a revolution in the anticlockwise direction, turn it in the clockwise direction until the timing marks are
aligned.
(2) Loosen the tension pulley fixing bolt, and then use the special tool and a torque wrench to tighten the fixing bolt to the specified torque while
applying tension to the timing belt.
Standard value:
3.5 Nm (2.6 ft. lbs.) <Timing belt tension torque>
CAUTION: When tightening the fixing bolt, make sure that the tension pulley does not turn with the bolt.
(3) Turn the crankshaft two revolutions in the clockwise direction so that the timing marks are aligned. After leaving it for 15 minutes, measure
the amount of protrusion of the auto tensioner.
Standard value (A): 3.8 - 4.5 mm (0.150 - 0.177 inch)
(4) If the amount of protrusion is outside the standard value, repeat the operation in steps (1) to (3).
(5) Check again to be sure that the timing marks of each sprocket are aligned.
>D< Timing Belt Front Lower Cover Timing Belt Front Upper Cover Installation.
