Galant ES L4-2350cc 2.4L SOHC MFI (1997)
Stabilizer Link: Testing and Inspection
Rear Suspension
Ball Joint Breakaway Torque Check
1. After shaking the ball joint stud several times, install the nut to the stud and use the special tool to measure the breakaway torque required to turn
the ball joint stud.
Standard value: 0.5-1.5 Nm (4-13 inch lbs.)
2. When the measured value exceeds the standard value, replace the stabilizer link.
3. When the measured value is lower than the standard value, check that the ball joint turns smoothly without excessive play. If so, it is possible to
use that ball joint.
Ball Joint Dust Cover Check
INSPECTION
If there are any cracks in or damage to the dust cover, replace the stabilizer link.