Galant ES V6-3.0L SOHC (2000)
STEP 14. Check the harness wires between rear door lock actuator switch (LH) connector E-11 and ground.
NOTE: After checking intermediate connector D-19, check the wires. If intermediate connector D-19 is damaged, repair or replace it. Refer to Harness
Connector Inspection.
If the harness wires between rear door lock actuator switch (LH) connector E-11 and ground are damaged, repair them.
The input signal from the rear door lock actuator switch (LH) should be able to be checked and the Theft-alarm system should work normally.
STEP 15. Check the rear door lock actuator switch (LH) connector E-11 and ETACS-ECU connector C-81 for damage.
If the rear door lock actuator switch connector E-11 and ETACS-ECU connector C-81 are damaged, repair or replace them. Refer to Harness Connector
Inspection.
The input signal from the rear door lock actuator switch should be able to be checked and the Theft-alarm system should work normally.
If the connectors are in good condition, go to Step 16.
