Galant ES V6-3.0L SOHC (2000)
DANGER: Wait at least 60 seconds after disconnecting the battery cables before doing any further work.
2. Disconnect the negative (-) and positive (+) battery cables from the battery terminals, and then remove the battery from the vehicle.
3. To deploy the air bag module (front passenger's side):
1. Remove the glove box.
NOTE: If the air bag module connector is disconnected from the dash wiring harness, both electrodes of the air bag module connector will be
automatically shorted to prevent unintended deployment of the air bag due to static electricity etc.
2. Remove the connection between the air bag module (front passenger's side) connector (red 2-pin) and the body wiring harness connector.
4. Connect the deployment wires, each six meters (20 feet) or longer, to the two leads of special tool MB686560 <air bag module (front passenger's
side) and side air bag module>, and cover the connections with insulation tape. The other ends of the deployment wires should be connected to
each other (short-circuited), to prevent sudden unexpected deployment of the air bag module.
5. Connect the clock spring, air bag module (front passenger's side), or side air bag module 2-pin connector to special tool MR372530 or MB686560
and move the deployment wires out of the vehicle.
