Galant LS V6-3.0L SOHC (1999)
STEP 5. Check the key reminder switch (Ignition key hole illumination light) power supply circuit.
1. Remove the steering column covers, upper and lower.
2. Disconnect the wiring connector from the key reminder switch.
3. Measure voltage between terminal number 2 and ground.
-
Voltage should be approximately 12 volts (battery positive voltage).
If approximately 12 volts, check that the malfunction is eliminated and go to Step 6.
If not approximately 12 volts, go to Step 7.
STEP 6. Check the key reminder switch (ignition key hole illumination light) ground circuit.
1. Connect key reminder switch connector C-59.
2. Remove ETACS-ECU connector C-86 from the junction block.
3. Measure continuity between ETACS-ECU harness side connector C-86 terminal number 15 and ground.
-
There should be continuity (0 ohm).
If there is continuity, go to Step 8 and check that the malfunction is eliminated.
If there is no continuity, go to Step 9.
STEP 7. Check the harness wires between key reminder switch connector C-59 and battery.
If any harness wires between key reminder switch connector C-59 and battery are damaged, repair them.
