Galant LS V6-3.0L SOHC (1999)
STEP 3. Inspect driver's door switch connector D-21 for damage.
If harness connector D-21 (located behind the driver's door switch) is damaged, repair or replace it. Refer to Harness Connector Inspection.
If harness connector D-21 is in good condition, go to Step 4.
STEP 4. Check the harness wires between driver's door switch connector D-21 and ETACS-ECU connector C-06.
If harness wires between driver's door switch D-21 and ETACS-ECU C-86 are damaged, repair them.
If harness wires are in good condition, go to Step 5.
NOTE: After inspecting intermediate connector C-67 and junction block connector C-87, inspect the wire. If intermediate connector C-67 and junction
block connector C-87 are damaged, repair or replace them. Refer to Harness Connector Inspection.
