Galant LS V6-3.0L SOHC (1999)
STEP 3. Check ETACS-ECU connector C-86 for damage.
If harness connector C-86 is damaged, repair or replace it.
Refer to Harness Connector Inspection. If harness connector C-86 is in good condition, go to Step 4.
STEP 4. Check the harness wires between the ignition switch (IG1) and ETACS-ECU connector C-86.
If the harness wires between the ignition switch and ETACS-ECU connector C-86 are damaged, repair it. Check that the malfunction is eliminated.
If the harness wires are in good condition, replace the ETACS-ECU. and then go to Step 5
NOTE: After inspecting junction block connector C-73, inspect the wire. If junction block connector C-73 is damaged, repair or replace it. Refer to
Harness Connector Inspection.
STEP 5. Check symptoms.
Confirm that the key hole illumination light operation is normal.
3. Ignition Buzzer Doesn't Turn Off with Ignition On
