Galant LS V6-3.0L SOHC (1999)
3.
Remove the following parts in the indicated order: (1) front driver's side under cover, (2) center panel assembly, (3) glove box, (4) I/P side cover
[RH], and (5) front passenger's side under cover. (Refer to Group 52A, Instrument Panel Removal, in the service manual).
4.
Locate the A/C controller as shown in the illustration above.
5.
Disconnect the heater resistor connector then move the connector harness out of the way to access the A/C controller.
6.
Disconnect the A/C controller connector. Locate the light blue/white wire on the harness side. Cut the wire about 1 inch from the connector. Use
electrical tape to cover each end of the open wires.
NOTE:
