Galant LS V6-3.0L SOHC (1999)
Brake Pedal Assy: Testing and Inspection
BRAKE PEDAL HEIGHT
1. Turn up the carpet etc. under the brake pedal.
2. Measure the brake pedal height as illustrated. If it is not within the standard value, adjust as follows.
Standard value: 175-178 mm (6.9-7.0 inches) [From the surface of melting sheet (floorboard) to the face of pedal pad]
1. Disconnect the stoplight switch connector.
2. Rotate the stoplight switch 1/4 turn clockwise to loosen.
3. Loosen the operating rod jam nut. Turn the serrations of the operation rod with pliers to adjust the brake pedal height to the standard valve.
4. Turn the stoplight switch until it contacts the stopper. During this Step, secure the pedal by drawing it forward by hand.
5. Adjust the stoplight switch so that it has the specified clearance as shown. Turn the stoplight switch 1/4 turn clockwise to secure.
6. Connect the connector of the stoplight switch.
7. Check to be sure that the stoplight is not illuminated with the brake pedal released.
3. Return the carpet, etc. to its original position.
BRAKE PEDAL FREE PLAY
With the engine stopped, depress the brake pedal two or three times. After eliminating the vacuum in the brake booster, press the pedal down by hand,
and confirm that the amount of movement before resistance is met (free play) is within the standard value range.
Standard value: 3-8 mm (0.12-0.31 inch)
If the free play exceeds the standard value, it is probably due to excessive play between the clevis pin and brake pedal arm.
Check for excessive clearance and replace faulty parts as required.
CLEARANCE BETWEEN BRAKE PEDAL AND FLOORBOARD
