Galant LS V6-3.0L SOHC (1999)
STEP 1. Check the ETACS-ECU power supply circuit [fusible link (1)] at the ETACS-ECU connector C-86.
1. Disconnect the ETACS-ECU connector C-86 and measure at the junction block side.
2. Voltage between terminal 16 and ground.
-
Voltage should be approximately 12 volts (battery positive voltage).
If not approximately 12 volts, go to Step 2.
If approximately 12 volts, go to Step 4.
STEP 2. Check the junction block connector C-86 for damage.
If the junction block connector C-86 is damaged, repair or replace it. Refer to Harness Connector Inspection.
The central door locking system should work normally.
If the connector is in good condition, go to Step 3.
