Galant LS V6-3.0L SOHC (1999)
STEP 4. Check the harness wires between wiper motor connector A-02 and front-ECU connector A-09X.
NOTE: After checking intermediate connector C-05, check the wires. If intermediate connector C-05 is damaged, repair or replace it. Refer to Harness
Connector Inspection.
If the harness wires between wiper motor connector A-02 and front-ECU connector A-09X are damaged, repair them. The windshield wiper should work
normally when the windshield wiper switch is set to all positions.
If the harness wires are in good condition, replace the front-ECU.
The windshield wiper should work normally when the windshield wiper switch is set to all positions.
Inspection Procedure F-3