Galant LS V6-3.0L SOHC (1999)
STEP 4. Check the fog light relay power supply circuit at the fog light relay connector A-06X.
1. Disconnect the fog light relay connector A-06X and measure at the relay box side.
2. Voltage between terminal 4 and ground.
-
Voltage should be approximately 12 volts (battery positive voltage).
3. Voltage between terminal 1 and ground.
-
Voltage should be approximately 12 volts (battery positive voltage).
If one of the checks above does not show approximately 12 volts, go to Step 5.
If both of the checks above show approximately 12 volts, go to Step 7.
STEP 5. Check the fog light relay connector A-06X for damage.
If the fog light relay connector A-06X is damaged, repair or replace it. Refer to Harness Connector Inspection.
The fog lights should illuminate.
If the connector is in good condition, go to Step 6.
STEP 6. Check the harness wire between fog light relay connector A-06X and battery.
If the harness wire between fog light relay connector A-06X and battery is damaged, repair it.
The fog lights should illuminate.
