Galant LS V6-3.0L SOHC (1999)
STEP 6. Check the harness wires between driver's seat belt switch connector D-25 and ETACS-ECU connector C-82.
NOTE: After checking intermediate connector C-67, check the wires. If intermediate connector C-67 is damaged, repair or replace it. Refer to Harness
Connector Inspection.
If the harness wires between driver's seat belt switch connector D-25 and ETACS-ECU connector C-82 are damaged, repair them.
The driver's seat belt switch input signal should be able to be checked and the functions, which are described in the "Technical Description (comment),"
should work normally.
If the harness wires are in good condition, replace the ETACS-ECU.
The driver's seat belt switch input signal should be able to be checked and the functions, which are described in the "Technical Description (comment),"
should work normally.
Inspection Procedure N-7
N-7 The driver's or front passenger's door switch is not sent to the ETACS-ECU.
The door switch signals are not sent to the ETACS-ECU.
