Galant LS V6-3.0L SOHC (1999)
1. Disconnect the rear door switch (RH) connector F-08 and measure at the harness side.
2. Resistance between terminal 3 and ground.
-
Should be less than 2 Ohms.
If open circuit, go to Step 18.
If less than 2 Ohms, go to Step 20.
STEP 18. Check the rear door switch (RH) connector F-08 for damage.
If the rear door switch (RH) connector F-08 is damaged, repair or replace it. Refer to Harness Connector Inspection.
The rear door switch (RH) input signal should be able to be checked and the functions, which are described in the "Technical Description (comment),"
should work normally.
If the connector is in good condition, go to Step 19.
STEP 19. Check the harness wire between rear door switch (RH) connector F-08 and ground.
If the harness wire between rear door switch (RH) connector F-08 and ground is damaged, repair it.
The rear door switch (RH) input signal should be able to be checked and the functions, which are described in the "Technical Description (comment),"
should work normally.
