Galant LS V6-3.0L SOHC (1999)
Inspection.
The driver's door switch input signal should be able to be checked and the functions, which are described in the "Technical Description (comment),"
should work normally.
If the harness connectors are in good condition, go to Step 24.
STEP 24. Check the harness wires between driver's door switch connector D-21 and ETACS-ECU connector C-86.
NOTE: After checking intermediate connector C-87, check the wires. If intermediate connector C-87 is damaged, repair or replace it Refer to Harness
Connector Inspection.
If the harness wires between driver's door switch connector D-21 and ETACS-ECU connector C-86 are damaged, repair them.
The driver's door switch input signal should be able to be checked and the functions, which are described in the "Technical Description (comment),"
should work normally.
If the harness wires are in good condition, replace the ETACS-ECU.
The driver's door switch input signal should be able to be checked and the functions, which are described in the "Technical Description (comment),"
should work normally.
STEP 25. Check the front passenger's door switch condition.
NOTE: The front passenger's door switch is grounded to the vehicle body via uts mounting screw.
Turn up the cup, and measure the resistance between the lower metal portion and the ground.
-
Should be less than 2 Ohms.
If open circuit, check the installation condition and correct it as necessary.
The front passenger's door switch input signal should be able to be checked and the functions, which are described in the "Technical Description
