Galant LS V6-3.0L SOHC (1999)
STEP 33. Check the harness wires between rear door switch (RH) connector F-08 and ETACS-ECU connector C-86.
NOTE: After checking intermediate connector C-71 and junction block connector C-78, check the wires. If intermediate connector C-71 and junction
block connector C-78 are damaged, repair or replace them. Refer to Harness Connector Inspection.
If the harness wires between rear door switch (RH) connector F-08 and ETACS-ECU connector C-86 are damaged, repair them.
The rear door switch (RH) input signal should be able to be checked and the functions, which are described in the "Technical Description (comment),"
should work normally.
If the harness wires are in good condition, replace the ETACS-ECU.
The rear door switch (RH) input signal should be able to be checked and the functions, which are described in the "Technical Description (comment),"
should work normally.
Inspection Procedure N-8
