Galant LS V6-3.0L SOHC (1999)
STEP 6. Check the harness wires between driver's door lock key cylinder switch connector E-14 and ETACS-ECU connector C-81.
NOTE: After checking intermediate connectors C-67 <1999 models only> and C-68, check the wires. If intermediate connectors C-67 <1999 models
only> and C-68 are damaged, repair or replace them. Refer to Harness Connector Inspection.
If the harness wires between driver's door lock key cylinder switch connector E-1 4 and ETACS-ECU connector C-81 are damaged, repair them.
The input signal from the driver's door lock key cylinder switch should be able to be checked and the functions, which are described in the "Technical
Description (comment)," should work normally.
If the harness wires are in good condition, replace the ETACS-ECU.
The input signal from the driver's door lock key cylinder switch should be able to be checked and the functions, which are described in the "Technical
Description (comment)," should work normally.
STEP 7. Check the front passenger's door lock key cylinder switch ground circuit at the front passenger's door lock key cylinder switch
connector E-06.
1. Disconnect the front passenger's door lock key cylinder switch connector E-06 and measure at the harness side.
2. Resistance between terminal 2 and ground.
