Galant LS V6-3.0L SOHC (1999)
9.
Remove the memory card from the LAPTOP and install it in the VCI. Connect the VCI to the vehicle. YOU MUST DISCONNECT THE
MUT-III LAPTOP.
10.
Reprogram the PCM, using automatic reprogramming. For reprogramming details, refer to TSB-03-00-015.
It will take up to 20 minutes to complete the reprogramming.
NOTE:
If the message "ECU at Current Level of VCI" appears, the PCM did not reprogram. Verify that the ROM ID is the same as the ROM ID listed
in the table.
^
If the ROM ID is the same as or higher than the ROM ID in the table, the PCM has been reprogrammed for this concern.
^
If it is not, verify that the correct database update is in the MUT-III and was transferred to the memory card, and that the memory card is
properly installed in the VCI.
CAUTION
DO NOT DISTURB THE HARNESS CABLES OR CONNECTIONS. INTERRUPTION DURING THE PROGRAMMING PROCESS
COULD CAUSE THE PCM TO LOSE DATA OR PREVENT FUTURE PCM REPROGRAMMING.
The table in Attachment A lists the PCM part numbers, ROM IDs, and corresponding vendor numbers that will display after reprogramming.
a.
After reprogramming is completed, the new ENG ROM ID and new A/T ROM ID will display alternately with the message "Turn IG SW
OFF" every four seconds. Note this information. Verify that the new PCM part number and ROM IDs are the same as those listed in
Attachment A.
11.
Using a ball-point pen, enter the appropriate PCM part number, vendor number, ROM ID #, this TSB number (TSB-05-13-004), your dealer code,
and the current date on the Engine Compartment Label (part no. MSSF-024G-00).
12.
Carefully remove all dirt and oil from a vacant area near the VECI label on the underside of the hood, and affix the Engine Compartment label.
13.
For 2000-2003 Eclipse and 2001-2003 Eclipse Spyder models with engine number lower than PS5961 only:
