Galant LS V6-3.0L SOHC (1999)
STEP 9. Check the harness wires between key reminder switch connector C-59 and ETACS-ECU connector C-06.
If any harness wires between key reminder switch connector C-59 and battery are damaged, repair them.
If the harness wires are in good condition, replace the ETACS-ECU. And then go to Step 10.
NOTE: After inspecting junction block connector C-77, Inspect the wire. If junction block connector C-77 is damaged, repair or replace it. Refer to
Harness Connector Inspection.
STEP 10. Check symptoms.
Confirm that the ignition key hole illumination operates normally.
2. Ignition Lamp Doesn't Go Out With Ignition On
The Ignition key hole illumination light does not go out when the ignition key is tuned to the "ON" position. (however, it goes out after 30
seconds.)
Ignition Key Hole Illumination Light Circuit
CIRCUIT OPERATION
Refer to the circuit operations other than those below.
-
The ignition key hole illumination light should become illuminated when the driver's door is opened while the ignition switch is "OFF" If the
ignition switch is turned "ON," the ETACS-ECU immediately switches off the illumination light.
TECHNICAL DESCRIPTION (COMMENT)
There may be no input signal from the ignition switch, or the ETACS-ECU may be faulty.
If multi-purpose fuse No.13 is blown, the harness may be short circuited.
TROUBLESHOOTING HINTS
-
Malfunction of the fuse
-
Damaged harness wires and connectors
