Galant LS V6-3.0L SOHC (1999)
STEP 3. Check driver's door switch connector D-21 for damage.
If connector D-21 is damaged, repair or replace it. Refer to Harness Connector Inspection.
If connector D-21 is in good condition, go to Step 4.
STEP 4. Check the harness wires between driver's door switch connector D-21 and ETACS-ECU connector C-86.
If the harness wires between driver's door switch and ETACS-ECU are damaged, repair them. Then check that the malfunction is eliminated.
If the harness wires are in good condition, go to Step 5.
NOTE: After inspecting intermediate connector C-87 and junction block connector C-87, inspect the wire. If intermediate connector C-87 and junction
block connector C-87 are damaged, repair or replace them. Refer to Harness Connector Inspection.
