Lancer L4-2.0L (4B11) (2008)
REMOVAL SERVICE POINTS
[[A]] CRANKSHAFT PULLEY REMOVAL
When removing the crankshaft pulley, slightly loosen the water pump pulley mounting bolts before removal of the drive belt.
[[B]] POWER STEERING OIL PUMP ASSEMBLY REMOVAL
1. Remove the power steering oil pump assembly with hose on it.
2. Tie the removed power steering oil pump with a string at a position where it will not interfere with the removal and installation of timing chain.
[[C]] ENGINE AND TRANSAXLE ASSEMBLY HOLDING
Install a special tool for holding the engine and transaxle assembly.
1. [Engine hanger MB991928 is used]
1) Assemble the engine hanger (special tool MB991928). Set the following parts on the base hanger.
^
Slide bracket (HI)
^
Foot x 4 (standard) (MB991932)
^
Joint x 2 (90) (MB991930)
2) Set the foot of the special tool as shown in the figure.
NOTE: Slide the slide bracket (HI) to adjust the engine hanger balance.
3) Mount special tool MB991454 to the power steering oil pump bracket and the engine hanger, and set it to special tool MB991928 to support
the engine and transaxle assembly.
2. [Engine hanger MB991895 is used]