Lancer L4-2.0L (4B11) (2008)
4.
Disengage the retaining clip and slide the arm assembly in the direction of the electrical connector as indicated.
5.
Carefully remove the thermistor wires from the retaining clip.
6.
Lift the fuel level gauge assembly away from the pump.
INSTALLATION
Installation is the reverse of Removal
1.
Insert the black thermistor wires under their retaining clip.
2.
Position the fuel level gauge arm assembly and slide it towards the bottom of the fuel pump assembly as indicated until the retaining clip
engages.
3.
Resecure the thermistor in its retaining clip and reconnect the connector.