Lancer L4-2.0L (4B11) (2008)
/Page-674026.png)
3. Measure the voltage between joint connector (CAN2) terminal 6 and body ground.
OK: 4.7 volts or less
4. Measure the voltage between joint connector (CAN2) terminal 19 and body ground.
OK: 4.7 volts or less
Q: Do all the voltages measure 4.7 volts or less?
YES : Go to Step 2.
NO : Go to Step 5.
STEP 2. Check the wiring harness between joint connector (CAN3) C-124 and ECM connector B-109 for a short to power supply. Measure the
voltage at joint connector (CAN3) C-124.
1. Disconnect joint connector (CAN3), and measure the voltage at the wiring harness side of joint connector (CAN3).
2. Turn the ignition switch to the ON position.
3. Measure the voltage between joint connector (CAN3) terminal 4 and body ground.
OK:4.7 volts or less
