Lancer L4-2.0L (4B11) (2008)
/Page-923004.png)
^
Turn the laptop computer on. If you're running on battery power and the charge indicator in the lower right hand corner of the screen does not show a
full charge, it is recommended that either the laptop battery be charged prior to beginning, or that reprogramming be completed with the A/C power
adaptor connected to the laptop.
^
Connect the USB cable to the VCI.
^
When the laptop displays the MUT-III main screen, connect the USB cable to the laptop.
^
Connect the MUT-III main harness with the blue DLC connection to the VCI.
^
Connect the blue connector of the MUT-III main harness to the vehicle's data link connector.
^
Turn the VCI power switch ON. Verify that the indicator lamp in the upper right corner of the screen is green.
CAUTION
DO NOT DISTURB THE HARNESS CABLES OR CONNECTIONS. INTERRUPTION DURING THE REPROGRAMMING PROCESS COULD
CAUSE THE CONTROL UNIT TO LOSE DATA OR PREVENT FUTURE REPROGRAMMING. IF THE USB CABLE IS DISCONNECTED
DURING THIS PROCEDURE, A WARNING MESSAGE WILL DISPLAY.
ECM Reprogramming
1. Conduct the following steps to reprogram the ECM.
a. Turn the ignition key or knob (F.A.S.T. equipped) to the ON position. If the vehicle is equipped with the F.A.S.T. System, the fob must remain in
the vehicle for the entire procedure.
b. If using MEDIC-II, from the main page, click the MUT-III STV icon at the top center of the screen.
c. Select "Special Function."
