Lancer L4-2.0L (4B11) (2008)
/Page-1374003.png)
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before
connecting or disconnecting scan tool MB991958.
3. Connect scan tool MB991958 to the data link connector.
4. Turn the ignition switch to the ON position.
5. Check DTCs using scan tool MB991958 to ensure entire SRS operates properly. At this time, check that no DTC except B1B12 is set.
DANGER: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
6. Turn the ignition switch to the "LOCK" (OFF) position. Disconnect the negative (-) battery cable and tape the terminal to prevent accidental
connection and air bag deployment.
]]B[[ KNEE AIR BAG MODULE INSTALLATION
CAUTION:
-
Take care not to bend or distort the knee air bag when installing it.
-
Take care that the surrounding components do not trap the air bag.
-
Take care that the front pillar trim clips or other parts do not interfere with the strap.
Connect the knee air bag module connector, then securely lock the locking button of the harness side connector.
]]C[[ POST-INSTALLATION INSPECTION
1. Connect the negative (-) battery cable.
2. Turn the ignition switch to the ON position.
3. Does the "SRS" warning light illuminate for approximately seven seconds, and go out?
4. If yes, the SRS system is functioning properly. If not, refer to DIAGNOSTIC TROUBLE CODE CHART <SRS-ECU>.
Inspection
INSPECTION
