Lancer L4-2.0L (4B11) (2008)
/Page-1381005.png)
-
The removed air bag module should be stored in a clean, dry place with the deployment surface facing up.
Using t-type long torx wrench (T30), a torx screw is loosened completely and removed.
[[E]] STEERING WHEEL ASSEMBLY REMOVAL
Use special tool MB990803 to remove the steering wheel.
[[F]] CLOCK SPRING REMOVAL
WARNING: The removed clock spring should be stored in a clean, dry place.
[[G]] PASSENGER'S (FRONT) AIR BAG MODULE CONNECTOR REMOVAL
1. Remove the grove box cover.(Refer to Interior Glove Box)
2. Slide the outer housing of the Passenger's (front) air bag module connector in the arrow direction shown, and disconnect the connector.
[[H]] PASSENGER'S (FRONT) AIR BAG MODULE REMOVAL
WARNING
-
The air bag module must not be measured with such equipment as an ohmmeter.
-
The air bag module must not be disassembled.
-
The removed air bag module should be stored in a clean, dry place with the deployment surface facing up.
