mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

CVT - Warning Lamp ON/Slow Down Message Displayed|Page 3815 > < CVT - Warning Lamp ON/Slow Down Message Displayed|Page 3809
Page 1
background image

Dipstick - Dipstick Tube: Customer Interest
CVT - Warning Lamp ON/Slow Down Message Displayed

No: TSB-10-23-005

DATE: June, 2010

MODEL: 2008-09 Lancer

SUBJECT:

CVT WARNING LAMP ON AND "SLOW DOWN" WARNING DISPLAYED ON M.I.D.

PURPOSE

The CVT warning lamp and a "SLOW DOWN" warning may display on the Multi-Information Display (M.l.D.) after driving at highway speeds during
hot weather for long periods. The warnings will turn off after the vehicle is operated at reduced speeds, allowing the fluid to return to normal operating
temperature. To correct this condition, reduce the CVT fluid level by 0.7 liters (0.75 qt.) and install a redesigned CVT fluid level gauge described in the
PARTS INFORMATION section of this TSB.

AFFECTED VEHICLES

2008-2009 Lancer built before December 22, 2008.

REPAIR PROCEDURE

Caution!

Begin this procedure with the engine and transmission cold.

1. Install a redesigned transmission fluid level oil gauge (p/n 2706A085).

2. Reduce the CVT fluid level in the transmission by 0.7L (0.75 qt.) as follows. Complete fluid cement is not necessary.

a. Raise the vehicle on a hoist.

b. Loosen the CVT oil pan drain plug 2 or 3 turns and use a small screwdriver or pick to loosen the drain plug gasket from the oil pan.

NOTE:

Have a new drain plug gasket (p/n 2705A012) unpackaged and ready to install onto the plug.

c. Completely remove the drain plug and gasket. Drain approximately 1 quart of CVT fluid into a CLEAN container. DO NOT dispose of the fluid

at this time.

NOTE:

An empty 1 qt. CVT container works well. CVT fluid must NOT be contaminated with dirt, regular A/T fluid or other oils. If using a funnel,
make sure it also is clean and there is no residue of regular A/T fluid or other oils.

d. Replace the gasket with the new one and reinstall the drain plug. Torque to 34 +/ 2 Nm (25 +/ 2 ft.-lbs.).

3. Lower the vehicle and check the COLD CVT fluid level. Make sure the level is at the "C" range (cold) of the gauge. If necessary, add some of the

drained fluid to bring it to the bottom of the "C" range.

CVT - Warning Lamp ON/Slow Down Message Displayed|Page 3815 > < CVT - Warning Lamp ON/Slow Down Message Displayed|Page 3809