Lancer L4-2.0L (4B11) (2008)
1. Push up the claws of the gearshift link clip using a screwdriver, etc., and then remove the gearshift link clip from the bracket together with the
cables.
INSTALLATION SERVICE POINTS
]]A[[ GEARSHIFT CABLE AND SELECT CABLE ASSEMBLY/GEARSHIFT CABLE CONNECTION (TRANSAXLE SIDE)/SELECT
CABLE CONNECTION (TRANSAXLE SIDE)/GEARSHIFT LINK CLIP INSTALLATION
CAUTION
Insert thoroughly the gearshift link clip, gearshift cable and select cable until they click in place.
1. After installing the new gearshift link clip to the cable bracket of the transaxle, install the gearshift cable and select cable to the cable bracket.
NOTE: The clip is reversible.
CAUTION
Check that the clip is securely installed.